Nextgen server now supports Blackberry
Unlocking in real-time.
Unlock BlackBerry 5xxx, 6xxx, 7Xxx
Using standard blackberry USB cable (as supplied with phone),
Phones not supported: X700, 7510 (iden),
5810, H700
Before attempting to unlock your
Blackberry with Nextgen Server please check that your Blackberry
has compatible firmware installed. To check the
software/firmware version of your Blackberry simply navigate
it's menu:-
Go to SETTINGS or
OPTIONS then ABOUT
If you have a firmware/software version
of: 4.0.X.XXX. no
firmware upgrade required, proceed direct to unlock.
Reading MEP unlock Code
Before you start please close down all
applications and close your firewall, if you are behind a router
you will need to open port 6967, failure to do so may result in
the client failing to connect to the server.
- Install the latest version of the
server client on your PC
- Connect up your Blackberry to your
PC using it's USB cable
|
If Windows now detects a new device
(this will happen the first time you connect your
blackberry to your PC, and the following you will need
to do only once) The drivers have been part of Windows
update from 2004, so should already be on your PC.
3. A new hardware wizard will appear.
Select “No, not this time” if asked about connecting to
the internet
4. Then on the next screen Select “Install Software
Automatically (Recommended)” Click on the “Next “ button
5. Windows will now search for the drivers.
6. Windows will now install the drivers.
7. Click on finish on next screen
8. Windows has finished installing New Hardware
You will only need to do this once per PC. The first
time you connect a blackberry to your PC. |
|
9. Start the Nextgen Server Client
10. Enter your User name & password
11 Make sure “main server” is set under Server Settings
12. Select “Berry” under Phone setting
13. Press “Get Berry Codes” on software
14. The server will now read and display the unlock codes on the
server client, estimated time 10 to 30 seconds
15. You can now disconnect the phone from your PC.
Entering the Unlock codes
1. Go to Options Menu
2. Select “SIM Card” menu option
3. You will now see SIM Information screen but no information
4. While holding “Shift” key Type “MEPD” or in case of 7100
“MEPPD” (no writing will appear on screen)
5. You will now see screen detailing SIM locks status, and you
will see active SM lock
6. To disable this now hold “ALT” key type “MEP2” or in case of
7100 “MEPP2” (no writing will appear on screen)
7. New dialogue window will appear asking for code
8. Enter the MEP code as displayed in the Server Client, press
ok, with jog dial
9. Phone will display “code accepted” your phone will now accept
any compatible SIM card.
( images above are of Step 2. Step 3 and Step 5)
